Skip to content
Planning tool · Room fit

Golf Simulator Room Fit Checker

Enter your room width, length and ceiling height to see what simulator configuration your space realistically supports — and which dimension is limiting you.

Step 1 / 2

Your room

Measure ceiling height at its lowest point in the swing zone — with any garage door fully open, including the track, opener and light fixtures.

Most golf simulator plans fail on one measurement, and it is almost always the ceiling. This checker takes your room width, depth, lowest usable ceiling height and usable screen-wall width and tells you which of those four is limiting you, what the room can realistically support, and what to verify against a manufacturer's published installation dimensions before you order anything.

Measure these four things first

  • —Ceiling height at its lowest point inside the swing zone — with any garage door fully open, including the track, opener and light fixtures.
  • —Room width wall to wall at the hitting position, not at the widest point.
  • —Room depth from the screen wall to the back of your stance, plus space to stand behind the ball.
  • —Usable screen-wall width, excluding outlets, panels, windows and door frames.

How your result is worked out

  • —Ceiling height is banded: below about 8 ft a conventional full-swing setup is not supported, 8–9 ft is special-case territory, 9–10 ft is workable for many golfers and 10 ft or more is a comfortable planning benchmark.
  • —Width, depth and screen-wall width are each scored against planning thresholds, and the lowest-scoring dimension is reported as your limiting constraint.
  • —Handedness changes the answer: dual-handed use needs usable width either side of centre and a launch monitor that reads both swings.
  • —Your result then lists the configurations the room supports — full enclosure, shorter screen with side protection, short-throw or ceiling-mounted projection, or a short-game and putting setup.

What this checker will not do

  • —It does not approve a specific product. Manufacturer installation dimensions and required clearances always override general planning guidance.
  • —It cannot see your swing. Overhead clearance mid-swing, measured with a club at the hitting position, is the only reliable test at a low ceiling.
  • —It does not account for mat or platform thickness, which reduces your effective ceiling clearance by the same amount.

Common questions

Where this fits in the decision